Home
Specials
Contact Us
Product Categories:
About Kandel Electronics
Visa | Master Card | Amex

RETIREMENT AUCTION!
SALE #1 — March 16-20
SALE #2 — March 21-26

Kandel Electronics is preparing for retirement
after serving our industry for 25 YEARS.
We are grateful for your support!

Click Here for More Information!
Product Search:  


Amplifiers > RF Solid State Amplifiers > 40AD1 Amplifier DC - 1MHz 40 Wattts CW by Amplifier Research

40AD1 Amplifier DC - 1MHz 40 Wattts CW

 Request a Quote

Product Description & Specs

The Model 40AD1 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 40AD1, when used with an RF sweep generator will provide a minimum of 40 watts of swept power. The Model 40AD1 is direct coupled throughout, allowing very low frequency signals to be used. Included is a front panel gain control which permits the operator to conveniently set the desired output level. Housed in a stylish, contemporary enclosure, the Model 40AD1 provides available RF power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for high power amplifiers. The Model 40AD1 amplifier uses universal input line voltage switching power supplies, thus allowing its use over a wide range of input voltages without wiring or switch position changes.
SPECIFICATIONS
POWER OUTPUT, CW: Minimum 40 watts; Typical 50 watts; Linear @ 1dB compression 25 watts minimum
FLATNESS: ?1.5 dB max.
FREQUENCY RESPONSE: DC - 1MHz instantaneously
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
GAIN (at maximum setting): 45 dB minimum
GAIN ADJUSTMENT (continuous range): 18 dB minimum
INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 max.
OUTPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 max.
MISMATCH TOLERANCE: 100% of rated power without foldback. Will operate
without damage or oscillation with any magnitude and phase of source and load impedance.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
HARMONIC DISTORTION: Maximum at 25 watts output, -25 dBc
THIRD ORDER INTERCEPT POINT: 54 dBm, typical
PRIMARY POWER: 90 - 135 / 180 - 270 VAC 50/60Hz single phase autoranging 400 watts maximum.

E-mail or call us at 800-582-8378 for more information.

Home   About   Contact   Category   Manufacturer   Search   Equipment Rentals   Weekly Specials

Copyright © 1998-2014, Kandel Electronics, Inc.